Color me surprised /s

Aww they’re babysitting

Yes! And keep us updated on the results!

He’s got a wonderful wig

He needs you to open one of those cans, for… quality assurance

Not a single thought behind those eyes

Rest in Piece, Pockets 💝🐾

Currently building an indirect backlight for my bathroom mirror. The outer ring is going to hold a piece of warm-white LED strip.

Huh, that’s weird. Double checking the part markings would’ve been my next suggestion, but the picture shows they’re correct. Maybe try a 1kOhm load resistor across Vout and GND, though in theory you should be able to see the output voltage without it.

Just to be sure: positive probe on Vin, negative probe on GND, measurement shows no minus sign?

Unlikely. Have you measured the voltage present at Vin?

How would even the most evil of snails be able to kill me if I am immortal?

Dangerous when wet 👀

Exceptional specimen, Sir

You’re welcome!

He can do the U!!

I haven’t got enough time on my hands right now to review the whole desingn, but one thing that jumps to mind is that you’ll want to use an antiparallel diode on each relay coil to suppress the negative voltage spikes when switching it off.

Be sure to keep adequate distance between high and low voltage traces. The ground plane seems awfully close to the N trace.

Other than that, I’d happily welcome more PCB and/or personal project discussions!

You’re very enthusiastic about beans and I like that

Hey you just coincidentally listed all of my interests

That’s me right now. Went through a breakup because, in hindsight, I wasn’t properly communicating my needs. We still get along very well which makes me think it could have worked out.