I spent a few days working at a house with 4 of the Husqvarna versions. I had a really good time watching them all take off and do a route and dock all minding their own business. The really cool part is you never even see your grass grow because it’s always being maintained.

You can’t use swipe typing on a physical keyboard 👎

I have this exact bottle for Dr pepper. The guy at the gas station charges me for a cup of ice when I refill it and it’s much cheaper than a 2 liter.

Because people literally don’t understand impulsive vs intrusive thoughts. I’m sticking to my guns on this one. The hive mind is wrong.

You also don’t act on intrusive thoughts. This meme demonstrates an impulsive thought, not an intrusive one.

Same. Which is why it’s intrusive. But I guess it’s cute for people to make light of others distressing neurological symptoms 🤷‍♂️

The people making these jokes don’t understand actual intrusive thoughts.

Not unless they can own slaves again.

You do it. Isn’t that the point?

They just repealed right to work in Michigan, and Meijer employees presumably used that leverage to significantly improve wages and benefits.

I care a lot about what happens to them. I hope there is a hell just so they can burn in it.

I use a dash of cheese in the flap and then I throw it on the griddle

A brief check of their site shows they use aluminum salts.

Ive been using schmitts, but it’s baking soda based just like that old spice probably is. I really loved using sweet pitti, which is unscented and uses mandelic acid. Imo, mandelic acid is the king of deodorants. Nothing is going to stop the sweat except aluminum though.

Big brain move.

The rabbit r1 is kinda interesting. Or would be, if it was either: a) an app that I have installed on my phone, replacing Google assistant, Bixby, siri, etc… b) a smartwatch. Why it needs to be this rediculous form factor is beyond me.

I was able to get it printing, but doing some calibration confirms that adjusting z offset made the bottom layer better. What’s the point in z offset specifically, vs just changing the gap when tramming or the initial layer height?

Increase in temp seemed to help!

This was the brim printing. But increasing temp did seem to help!

This is a really interesting idea! Ill give it a try.